Mi-au raspuns cam rapid, de apreciat.
Partea usor frustranta, si ma asteptam sa nu inteleaga din prima, e ca desi am zis...
"
Please note that forcing it in place by tightening the nuts will most likely crack it. Or the turbo, or the uppipe. 3.5mm difference is just too much to compensate by tension. Tension that at it's turn can get highly destructive."
Ei cer dupa cum urmeaza.
"
Could you send me a picture of the downpipe fully bolted to the turbo, and where the bottom hangar portion lands while it's bolted down please?"
Deci va fi o zi lunga, incercand sa le demonstrez care-i baiul. Dar pentru 1300USD, crek merita.
Brb
_______________________________
Vreo 10 ore mi-a luat sa le fac un video de 17 minute. Dar macar i-am lamurit in minim 3 moduri.
Adica inca o zi pierduta amboutzulea, si inca n-am taiat si sudat nimic pe panarama asta de teava overpriced.